If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Im just in the finishing stages of fitting a 2ltr 8v, so its basically a GTE now, as i changed the entire cars wiring for GTE stuff. Unfortunately the rear bumper got ripped off, so its just got a std GTE on fitted at the moment in white, looks a bit odd but ill get it sprayed in a similar colour soon.
i'm hoping to aquire a 5dr gl in the not too distant future. had my eye on bumpers from tuning.co.uk but it looks like they have scaled down on what they sell 4 mk2's now.
whats the colour and code of the paint too?
my aim is a two tone midnight blue upper and mat black under, but have to see if my dreams can be realised!
The front bumper is a genuine mk3 gsi, which i put the s-type splitter onto and modified the 'big mouth' opening. The rear bumper is a rieger infinity one, with the insides ripped out, and bits of a gte bumper bonded into it.
The paint was a one off mix that i had lying around, but i ran out doing the shell. The bumpers are the closest match i could get, and that was an audi colour, but the had to be lacquered, wheras the rest of the car is just painted in celly and polished up.
Its not a great finish, but im pleased with it as i have done all the work myself, it has never been near a bodyshop or workshop.
Im afraid i dont at the moment, although i can take pics of the fron tonight as i have the front bumper off the car, but the rear is in a mess after an incident with a speedbump
Im afraid i dont at the moment, although i can take pics of the fron tonight as i have the front bumper off the car, but the rear is in a mess after an incident with a speedbump
That would be perfect mate ,i just need to see what needs cut and what needs putting in for it to line up .
Basically i cut the front bumper mount box sections off, and welded in new brackets drilled to fit the gsi brackets. For the sides, i cut out the mk3 mounting points, and bonded in the mounting brackets from a std mk2 bumper, although if the mounts are good on the mk3 bumper, you can just drill holes into the lip on the wing and bumper mount point and bolt them on. ill get some pics so you can see properly
I love this motor seen it on MIG, i havea 5dr and want to do something similar with the mk3 bumpers an i like that side skirt, was it easy to fit? An how much did you pay for the bumpers and sideskirts if you don't mind me asking
Comment