If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Have you tried taking off the plug to the sender unit off and putting it directly to earth, this should send the needle to the top showing a full tank,
This will work on both digital and analogue gauges
Yeah mate ignition was on when tested going to search through tomorrow when at work, found some on eBay but they want to know the ohm range might have to pull out the sender and check
Ok just wanted to check. Another thing to check is the continuity between the sender unit and the wire on the back of the clock just to make sure the wiring is ok
Checked this at the same time mate, will need to either fill up the tank or take the sender out to get a reading for the full so I can get a gauge that works.
Comment